HGPC-2000 Pressure SwitchBack to list
下一篇：PB8900
上一篇：没有了
1. Summary
HGPC2000 digital pressure meter adopts high performance pressure resistance sensor, use SCM circuit, anti-interference software design, high performance low temperature drift signal amplification processing circuit. When the measured pressure reaches the set value, the output switch signal is provided with two switch contacts, which is convenient to connect the electric control, and has the advantages of simple operation, high measuring precision and good long-term stability. Display using high brightness LED digital tube or LCD liquid crystal display, intuitive reading, good seismic performance, long service life。
2. Key Characteristics
HGPC2000 digital pressure meter adopts high performance pressure resistance sensor, use SCM circuit, anti-interference software design, high performance low temperature drift signal amplification processing circuit. When the measured pressure reaches the set value, the output switch signal is provided with two switch contacts, which is convenient to connect the electric control, and has the advantages of simple operation, high measuring precision and good long-term stability. Display using high brightness LED digital tube or LCD liquid crystal display, intuitive reading, good seismic performance, long service life。
2. Key Characteristics
1、Measuring Range： 0～60MPa
2、Power：24VDC、1.5V Dry battery、or 3.6V lithium battery
3、Control Output：One or two normally open, normally closed contact
4、Accuracy：0.5%FS、0.2%FS
5、Screen：four bit LED or LCD
6、Contact Load：5A/250VAC
7、Control Range：zero to full range can be set
8、Acquisition speed：80 times per second
9、Overload Limit：150%FS
10、Working Temperature：－20℃～60℃
11、Connection：1/2NPT,1/2BSP
2、Power：24VDC、1.5V Dry battery、or 3.6V lithium battery
3、Control Output：One or two normally open, normally closed contact
4、Accuracy：0.5%FS、0.2%FS
5、Screen：four bit LED or LCD
6、Contact Load：5A/250VAC
7、Control Range：zero to full range can be set
8、Acquisition speed：80 times per second
9、Overload Limit：150%FS
10、Working Temperature：－20℃～60℃
11、Connection：1/2NPT,1/2BSP
Upper limit, lower limit setting and zero calibration
1．Press（SET）button，H is the Upper limit，L is the Lower limit，press（▲）button increase the figure，press（▼）button reduce the figure.Set the Upper limit and the Lower limit。Press（↲）button to finish。
2．If there have (Zero) button，press (Zero) button to calibrate zero.If there is no (Zero) button，press（▲）（▼）button together 3 seconds to calibrate zero.Do not calibrate zero when the actual pressure is not zero.
NOTE: DO NOT PULL THE SHELL DURING INSTALLATION!
